Explorer Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello to all i am new here i have had my 2003 ford explorer eddie bauer v8 4.6l for a while now my on problem is it over heated and when it did it had no power when accelerating needle went straight to hot an hour later back to cold flushed and changed thermastat. Runs good for about an hour and it goes right back to hot and no power again i read that it could be the cyclinder head temperature sensor but for the life of me i can not find it. If anyone has any suggeations or know where to find it please let me know thank you all
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
Hello again i hope this is a helpful answer the cylinder heating thermastat sensor is almost in the block you have to remove the thermastat upper housing and the alternator its located inaide to the right just about at the begging if you know what you are looking for you will see it fast i will post picks or a video of the job thank you all again have a great day
 
1 - 2 of 2 Posts
Top