Explorer Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I just bought a 2004 Ford Explorer XLS with the 7 pin tow connector next to the hitch. I want to connect my Tekonsha 90195 P3 brake controller with the Tekonsha 3035-P Brake Control Wiring Adapter, but am not able to find the connector in the Explorer to mate this cable too. I looked behind and around the glove box but see no such connector. Also looked around the area of the hood release on the drivers side and no luck. Any help would be appreciated.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #2
OK I finally found it. It was behind the glove box toward the center of vehicle. Where it came out of the factory harness, it was doubled back up and totally covered with black tape against the harness. It was not visible to the naked eye and I finally was able to locate it by feel. Then cut the black tape off which exposed the brake harness connector.
 
1 - 2 of 2 Posts
Top